In the construction of ceramic fiber paper, each construction situation is more or less different,Ceramic Fiber Paper so everyone must pay attention to its construction points and techniques during construction,Ceramic Fiber Paper and choose a suitable construction method for operation. So how does ceramic fiber paper construct its roof and walls? What construction steps do we need to follow? Next,Ceramic Fiber Paper let's take a brief look at it through the introduction below.
Construction on the roof: When unwinding the roll,Ceramic Fiber Paper ensure that it is aligned and tensioned. Lay it on the other side of the eaves. Also leave an extra 20 cm of roll felt. Use a special fixture or double-sided tape to fix it on the outermost purlin and lay ceramic When using fiber paper, the veneer faces the indoor side and is perpendicular to the purlin. Leave an extra 20 cm roll felt at one eaves. Use a special clamp or double-sided tape to fix it on the outermost purlin,Ceramic Fiber Paper between the two rolls of cotton. Connect them together by using a stapler on the veneer fins. Pay attention to keeping the tension and alignment of the ceramic fiber paper and the joints between the rolls tight. When longitudinal laps are needed,Ceramic Fiber Paper the lap joints should be arranged in At the purlin; install the roof color steel plate,Ceramic Fiber Paper remove the fixtures at the eaves on both sides,Ceramic Fiber Paper and use the reserved 20 cm veneer to close the glass wool edge. According to the needs of the project, to avoid the generation of cold bridges,Ceramic Fiber Paper you can consider padding some hard materials on the purlin Insulation Materials.
Construction on the wall: pay attention to keeping its tension, alignment,Ceramic Fiber Paper and the joints between the rolls tight. Stick the cotton to the indoor side,Ceramic Fiber Paper roll it from the eaves to the foot of the wall, fix it on the bottom purlin with double-sided tape, leave an extra 20 cm,Ceramic Fiber Paper close the glass wool, install the color steel plate,Ceramic Fiber Paper and place the ceramic fiber paper over the wall top purlin Cut it off at 20 cm and fix it with double-sided tape.
